Ingressus IV and slave devices
Ingressus IV is FingerTec’s latest advance access
controller which supports access control up to 4-doors. In short, Ingressus IV
can be described as a 4-In door controller. A total of 4 Wiegand input ports is
available in Ingressus IV.
It links up with 4 units of 26-bits Wiegand readers (iKadex or kKadex) to capture card ID or password details as access credentials. The role of each Wiegand reader is to control their designated door to limit the “in” access. Thus, there must be a push release button (some called it REX, request exit button) installed inside to unlock the door and exit the zone that it was assigned under.
Through the implementation of this system, users will only
need to verify their credentials once when coming into a zone and they are free
to leave from a different zone so long as an anti-passback isn’t in place.
Hence, we called it the 4-In doors controller. The reason why it is labelled as
such is because of the connection between the In and Out devices:
In device
|
Out device
|
Apply to
|
kKadex/iKadex
|
Push release button
|
1
|
kKadex/iKadex
|
Push release button
|
2
|
kKadex/iKadex
|
Push release button
|
3
|
kKadex/iKadex
|
Push release button
|
4
|
However, do note that advance access control features
such as anti-passback, interlocking, multi users unlock and unlock combination
will still take effect in Ingressus IV.
In order to unleash the full power of Ingressus and
control In-Out access at all 4 doors, you can link up with 8-units of RS 485
reader (R2c). Each door will be secured by 2 units of R2c and this will limit
all the in-out activities.
The slave fingerprint scanner is capable of capturing
fingerprints and card details as access credentials for its master, the
Ingressus, to verify. The R2c communicates with Ingressus via the RS485
network. Each R2c comes with a “dip-switch” to identify its ID number, ranging
from 1 to 8. The connection between each ID and door are as below:
|
The ID of R2c for In
|
The ID of R2c for Out
|
Apply to
|
|
1
|
2
|
1
|
|
3
|
4
|
2
|
|
5
|
6
|
3
|
|
7
|
8
|
4
|
In the case of budget or special requirements, you may
mix and match the slave devices with R2c, kKadex, iKadex and push release
button to secure the doors. For example:
|
In device
|
Out device
|
Apply to
|
|
kKadex/iKadex
|
Push release button
|
1
|
|
R2c (ID 3)
|
R2c (ID 4)
|
2
|
|
kKadex/iKadex
|
Push release button
|
3
|
|
R2c (ID 7)
|
R2c (ID 8)
|
4
|
Kindly ensure that you set the correct “dip-switch” at
R2c so that Ingressus can identify its position.
0 comments:
Have any questions or inquiries about FingerTec? Drop your input here.